Large Push Ratio (LPR) Gas Genset

The combination of gas genset and dynamic flywheel is adopted in Tellhow EST LPR gas genset, which solves the problem of using gas genset to drive the same power motor. The product is a fully integrated power supply device, which can overcome the disadvantage of too small torque of gas genset on the premise of using the high power generation efficiency of gas genset. It is used in non grid system where high power motor starts frequently

LPR gas genset  1600 kW - 2000 kW

 

Description:

 
The combination of gas genset and dynamic flywheel is adopted in Tellhow EST LPR gas genset, which solves the problem of using gas genset to drive the same power motor. The product is a fully integrated power supply device, which can overcome the disadvantage of too small torque of gas genset on the premise of using the high power generation efficiency of gas genset. It is used in non grid system where high power motor starts frequently.

 

Features:

Cummins® Robust engine – Robust 4-cycle lean burn gas internal combustion engine utilizing full electronic engine management and monitoring.

 

Exhaust Emissions – Lean burn technology provides exhaust emissions levels as low as 250 mg/Nm3 (0.5 g/hp-hr) NOx.

 

Fuel Flexibility – Ability to run on natural gas as well as alternative gaseous fuels with lower BTU properties and varying Methane Numbers (MN), including well gas.

 

Permanent Magnet Generator (PMG) – Offers enhanced motor starting and fault clearing short circuit capability.

 

Magnetic suspension flywheel energy storage (MFES) - HHE magnetic suspension flywheel rotor rotates at high speed in vacuum chamber. In the charging state, it can convert the electric energy into kinetic energy, and the rotational speed is up to 30000 revolutions per minute, which is stored as energy; in the discharging state, it is equivalent to a generator, which uses the inertia of the speed drop to convert kinetic energy into electrical energy to release the load.

 

Alternator – Several alternator sizes offer selectable voltage and temperature rise with low reactance 2/3 pitch windings; low waveform distortion with non-linear loads, fault clearing short-circuit capability, class F or H insulation (see Alternator Data Sheet for details), bearing and stator RTDs and anti-condensation heater. Mechanically strengthened for use on utility paralleling with unreliable grid.  

 

Control system –EMC4.0 controller can precisely control the load capacity of the generator set and the actual power of the load to ensure the output power of the flywheel plus the output power of the generator set can fully meet the peak power when the motor starts, so as to realize the smooth start of the motor. EMC4.0 has accurate frequency and voltage regulation, alarm and status information display, over-current protection, output metering, automatic shutdown in fault detection and user interface panel installed on the generator set. An optional remote operation panel is also available.

 

Cooling system - it can provide heat exchanger, remote cooling fan

 

Warranty and Service – Cummins and Tellhow jointly provide comprehensive warranty and worldwide distributor network that can provide all levels of service from replacements parts to performance guarantee programs.

 

50Hz 60Hz
Model KW Engergy shorage capacity(KWH) Connection mode Model KW Engergy shorage capacity(KWH)

Connection mode
LPB1600G5 1600 3 Direct connection LPB1600G6 1600 3 Gearbox connection
LPB1800G5 1800 3 Direct connection LPB1600G6 1800 3 Gearbox connection
LPB2000G5 2000 3 Direct connection LPB1600G6 2000 3 Gearbox connection

* Genset is capable of operating between 0.8 lagging and 1.0 power factor unless specified otherwise. All fuel consumption and heat balance data is at 1.0 power factor.

Read more!